Sonicare HX6921/06 User Manual download pdf (Page 10)

Note: There is a small gap between the colour code ring and the handle.

Charging your Sonicare

1 Put the mains plug of the charger or sanitiser in the wall socket.

2 Place the handle on the charger or sanitiser (Fig. 5).

, The ashing light of the battery gauge indicates that the toothbrush

is charging.

- 1 solid green LED indicates that the toothbrush is 34-66% charged.

- 2 solid green LEDs indicate that the toothbrush is 67-94% charged.

- 3 solid green LEDs indicate that the toothbrush is fully charged.

Note: If the battery charge of your Sonicare is low, you hear 3 beeps and

1 LED of the recharge gauge ashes yellow for 30 seconds after completing

the brushing cycle.

Note: To keep the battery fully charged at all times, you may keep your Sonicare

on the charger when not in use. Once the Sonicare is fully charged, the charger

draws minimal energy from the wall socket.

Note: It takes at least 24 hours to fully charge the battery.

Using the Sonicare

Brushing instructions

1 Wet the bristles and apply a small amount of toothpaste.

2 Place the toothbrush bristles against the teeth at a slight angle

towards the gumline (Fig. 6).

3 Press the power on/off button to switch on the Sonicare.

4 Apply light pressure to maximise Sonicare’s effectiveness and let

the Sonicare toothbrush do the brushing for you. Do not scrub.

5 Gently move the brush head slowly across the teeth in a small back

and forth motion so the longer bristles reach between your teeth.

Continue this motion throughout your brushing cycle.

Note: To make sure you brush evenly throughout the mouth, divide your

mouth into 4 sections using the Quadpacer feature (see chapter ‘Features’).

ENGLISH10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 251 252

No comments

Sonicare HX6921/06 User Manual Page 10