Sonicare HX6921/06 User Manual download pdf (Page 13)

intervals during the brushing cycle. See section ‘Brushing modes’

in chapter ‘Using the Sonicare’ (Fig. 7).

The Quadpacer feature on this type has been activated. To deactivate or

reactivate the Quadpacer feature:

1 Place the handle with a brush head attached on the plugged-in charger.

2 Press and hold the mode button for 2 seconds.

, You hear 1 beep to indicate the Quadpacer has been deactivated

or you hear 2 beeps to indicate the Quadpacer has been activated.

Cord wrap on deluxe charger (specic types only)

If your type includes the deluxe charger cover and base, the travel charger

is pre-installed inside the cover. If you want to shorten the mains cord,

you can store excess cord in the cord wrap feature built into the charger

base.

1 To separate the charger cover from the charger base, press the two

grey snap bars on the charger base and pull the white charger cover

upwards. (Fig. 9)

2 Wrap excess power cord around the grey charger base as shown

in the picture. Be sure to wrap the cord on the inside of the two

snap levers. (Fig. 10)

3 When you have stored the excess cord, guide the mains cord

through the small groove in the rear of the grey charger base. (Fig. 11)

4 To reattach the charger cover, press it down over the charger base

until it snaps into place.

Tip: For extra convenience during travel, you can remove the travel charger

and use it without the charger cover and charger base.

Cord wrap on sanitiser with integrated charger

(specic types only)

- If your type includes the sanitiser, you can store excess cord in the

cord wrap feature built into the bottom of the sanitiser. (Fig. 12)

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 251 252

No comments

Sonicare HX6921/06 User Manual Page 13