Sonicare HX8911/02 User Manual download pdf (Page 9)

Using the appliance

Brushing instructions

1 Wet the bristles and apply a small amount of toothpaste.

2 Place the toothbrush bristles against the teeth at a slight angle

(45 degrees), pressing rmly to make the bristles reach the gumline

or slightly beneath the gumline. (Fig. 4)

Note: Keep the center of the brush in contact with the teeth at all times.

3 Press the power on/off and mode button to switch on the Philips

Sonicare.

4 Apply light pressure to maximise Philips Sonicare’s effectiveness

and let the Philips Sonicare toothbrush do the brushing for you.

Do not scrub.

5 Gently move the brush head slowly across the teeth in a small back

and forth motion so the longer bristles reach between your teeth.

Continue this motion throughout the brushing cycle.

6 To clean the inside surfaces of the front teeth, tilt the brush handle

semi-upright and make several vertical overlapping brushing strokes

on each tooth (Fig. 5).

Note: To make sure you brush evenly throughout the mouth, divide your

mouth into 4 sections using the Quadpacer feature (see chapter ‘Features’).

7 Brush each section for 30 seconds for a total brushing time of

2 minutes. Start with section 1 (outside top teeth) and then brush

section 2 (inside top teeth). Continue with section 3 (outside

bottom teeth) and nally brush section 4 (inside bottom teeth)

(Fig. 6).

8 After you have completed the brushing cycle, you can spend

additional time brushing the chewing surfaces of your teeth and

areas where staining occurs. You can also brush your tongue,

with the toothbrush switched on or off, as you prefer (Fig. 7).

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Sonicare HX8911/02 User Manual Page 9